What size hole do I need to drill for a door knob?

Are all door knob holes the same size?

Standard cross bores measure about 1 inch in diameter. The latch bore can be found on the edge of the door, and its standard size is 2 1/8 inches. Also measure the door’s backset, which is the length straight from the middle of the cross bore out to the door’s edge.

Do you need a drill to install a door knob?

When installing a doorknob — more correctly called a lockset — you need to drill two holes into the door. One is for the knobs and the spring-loaded mechanism they turn, and the other is for the barrel. In addition, you need to make a hole in the jamb into which the barrel fits.

How do you unlock a door knob that has a hole on the side?

When it comes to unlocking a doorknob that has a hole on the side, the solution is simple. Using something small like a paper clip or even a coat hanger, you can insert the tool and move it until it catches. The locking mechanism should release, and you will be able to turn the doorknob once again.

What is the hole on the side of a door knob for?

The Bore hole is the large diameter hole where the door knob is mounted. The standard sized bore hole is 2 1/8″ in diameter. Through the edge of the door there is a 1″ cross bore that extends from the edge of the door through the bore hole. This cross bore is where the latch is installed.

IT IS IMPORTANT:  Quick Answer: How do you remove codes from Kwikset 888?