Frequent question: How do I reset a Kwikset 910 lock?

How do you change the code on a Kwikset 910?

For instructions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. 1. Keep door open. Press the Program button once.

  1. Make sure the door is open. Press the Program button once.
  2. Press checkmark symbol once.
  3. Enter user code. …
  4. Press lock symbol once.

How do I reset my Kwikset lock code?

How do I reset a code on my Powerbolt?

  1. Insert functioning key & turn 1/4 turn clockwise.
  2. Insert & remove the SmartKey learn tool. Remove functioning key.
  3. Insert new key & turn 1/2 turn counter-clockwise. Done. Your lock is now re-keyed! “”

How do I delete all codes on Kwikset SmartCode 910?

How do I delete all user codes on my SmartCode?

  1. Keep door open. Press the Program button once. …
  2. Press Lock button once.
  3. Enter Mastercode.
  4. Press Lock button once.
  5. Press “9” six times.
  6. Press Lock button once.
  7. Press “9” six times.
  8. Press Lock button once.

How do you unlock a Kwikset lock code?

To program the first user code:

  1. Press the button marked “program button” once.
  2. Using the keypad, enter a 4- to 8-digit code.
  3. Press the ‘LOCK” button to save the code.
  4. Extend the bolt by pressing- the “LOCK” button.
  5. Enter the new code number. The bolt should retract.
IT IS IMPORTANT:  Best answer: Can you use a door closer outside?

How do you reset a Kwikset lock without the code?

You may reset the lock by pressing the Premis Button “A” on the back panel for 20 seconds.

How do I remove code from Kwikset Smart lock?

Delete A User Code:

  1. Make sure the door is open.
  2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. …
  3. Press 2 to delete a user code. …
  4. Press Kwikset.
  5. Enter the user code you wish to delete. …
  6. Enter the user code again.
  7. Press Kwikset.

How do I reset the master code on a Kwikset 913?

How do I program my SmartCode 913 lock?

  1. Open the door.
  2. Remove battery cover.
  3. Press the program button once.
  4. Enter new user code.
  5. Press lock button.
  6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do you reset a Kwikset lock 913?

Press and hold the program button while reinserting the battery pack. Keep holding the button for 30 seconds until it beeps. Press the program button once more in 20 seconds the LED will flash green and you will hear a beep. 0 of 4 found this helpful.