What is a heater blend door?

A blend door is mounted within the heating and air conditioning system and pivots to divert warm or cool air into different passages within the system to keep the passenger area at the desired temperature. … When cool air is desired, a blend door is closes so that no heat enters the passenger area.

What are the symptoms of a bad blend door actuator?

Signs You Need A New Blend Door Actuator

  • Knocking. Knocking sounds can almost always be attributed to a failing blend door actuator. …
  • Clicking. …
  • Any Other Strange Noises. …
  • Inconsistent Airflow. …
  • Inconsistent Temperature. …
  • Wrong Temperature.

How much does it cost to replace a blend door?

The average cost ranges from $100 to $400 for an HVAC blend door actuator replacement in your vehicle.

What does a bad blend door actuator sound like?

When you start the car, or just the AC system, and notice a knocking sound like someone tapping on your door, that is indicative of a problem with the blend door actuator. Inconsistent Airflow: If the blend door is moving back and forth, then the airflow will be diverted incorrectly or maintained incorrectly.

How long does it take to fix a blend door actuator?

Replacing the blend door actuator is actually a fairly simple process, and it should take no more than an hour. So the labor will cost you around $75 – $150 depending on labor rates at your local repair shop. In general, you can expect the total cost to be no more than $400.

IT IS IMPORTANT:  What is a double sided deadbolt?

Why do blend door actuators fail?

What Causes a bad blend door actuator? A blend door actuator is linked to an air control door pivot found on the last drive of the unit; a plastic gear set is frequently rotated from one side to another by the electric motor.An actuator can become faulty if the plastic gear set turns out to be fragile and it breaks.

Can I drive with a bad actuator?

Can I drive with a blend door actuator problem? Driving with a bad blend door actuator may not be comfortable, but it won’t hurt the vehicle.

Can you manually move a blend door?

The actuator is what needs replacing. The arm/hinge that is moving up and down is just the thing you need to grab with your finger to manually flip the blend door over to the hot temp side.

How does a blend door break?

On most vehicles, the blend door hangs on a vertical or horizontal axis, so turning a corner or changing the fan speed can cause a broken blend door to randomly swing between the hot and cold positions.

Can you adjust blend door actuator?

A blend door actuator is an electric HVAC motor that works together in harmony with sensors connected to your climate control system. When you adjust the actuator airflow intensity or turn the temperature dial-up and down, the input signal passes through the actuator.