How do you reset a Kwikset halo lock?

How do I reset my Kwikset halo lock code?

Hold down the black button in the center of the lock, just above the LED light, while lowering the battery pack back into its slot. 4. Keep holding down the button for 30 seconds, or until the light flashes red.

How do I factory reset my halo?

If you have already paired your Halo band from your phone’s Bluetooth settings: Go to Bluetooth settings on your phone, find your band, and select “Forget this device.” Factory reset your band by pressing the button twice. On the second press, hold the button down until you see a blinking purple light.

How do I reset my Kwikset 910 lock code?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.

How do you enter codes on Kwikset halo lock?

How do I add/delete a user code on my Powerbolt 2?

  1. Make sure the lock is unlocked and the door is open.
  2. Enter your Mastercode – for new install, default is 0-0-0-0.
  3. Press the lock button. …
  4. Press 1.
  5. Press the lock button. …
  6. Enter a new User Code. …
  7. Press the lock button. …
  8. Test the code: While your door is open, lock it.
IT IS IMPORTANT:  Is baking soda good for cleaning glass shower doors?

Can I unlock Kwikset Halo remotely?

To grant guests access, you can unlock Halo remotely using the Kwikset App or add and share access codes (with or without specific schedules) with your guest.

Why is my Kwikset lock not syncing?

If the lock has already been installed on the door, remove the interior assembly from the mounting plate. Make sure the batteries are installed, and bring the interior assembly next to the controller. … Reinstall the battery pack. Perform the pairing process while the interior and exterior are connected.

How do you reset a Kwikset lock without the code?

You may reset the lock by pressing the Premis Button “A” on the back panel for 20 seconds.

How do I reset my Kwikset SmartCode master code?

How do I enable/delete the mastercode on my Smartcode?

  1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).
  2. Enter new Mastercode.
  3. Press Lock button once.
  4. Re-enter Mastercode.
  5. Press Lock button once. …
  6. Make sure switch #3 is on, and press the Program button once.

How do I set my Kwikset auto lock?

How to enable/disable Auto-Lock on my Powerbolt 2?

  1. Make sure the lock is unlocked and the door is open.
  2. Enter your existing Mastercode.
  3. Press the lock button. You will hear one beep.
  4. Press 1 – 1.
  5. Press the lock button. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful.