How do I reset my Kwikset lock after changing the battery?

Do I have to put in new code after I change batteries in my Kwikset?

If I Change The Battery In My Kevo Fob, Do I Have To Enroll It Again? No, the Kevo fob stores all of the information in memory which does not require power. When you insert a new battery, it will work just like it did before the battery was removed.

How do I reprogram my Kwikset SmartCode?

How do I program my SmartCode 913 lock?

  1. Open the door.
  2. Remove battery cover.
  3. Press the program button once.
  4. Enter new user code.
  5. Press lock button.
  6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do you put a Kwikset lock in pairing mode?

Pairing Your Lock with the Xfinity Home Touchscreen

  1. On your Home screen: …
  2. Enter your Master Keypad Code.
  3. Select Categories > Home Devices > Door Locks and then Add Door Lock.
  4. Make sure that your Lock is ready for pairing. …
  5. When your Lock is ready for pairing, tap Next.

How do you reset a Kwikset lock without the code?

You may reset the lock by pressing the Premis Button “A” on the back panel for 20 seconds.

IT IS IMPORTANT:  Which half of hinge goes on door?

How do you reset a Kwikset 910 lock?

How to perform a factory reset:

  1. Remove the batteries.
  2. Press and hold the lock button on the keypad.
  3. Place the batteries back in (while still holding the button)
  4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

How do I reset my Kwikset Smartcode master code?

How do I enable/delete the mastercode on my Smartcode?

  1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).
  2. Enter new Mastercode.
  3. Press Lock button once.
  4. Re-enter Mastercode.
  5. Press Lock button once. …
  6. Make sure switch #3 is on, and press the Program button once.

Why is my Kwikset lock not pairing?

My Lock Won’t Pair

Remove the battery pack. Press and hold the A or Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the Lock beeps and the status LED flashes red. View button locations for your Lock model.

How do you remove a code from a Kwikset lock?

Delete A User Code:

  1. Make sure the door is open.
  2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. …
  3. Press 2 to delete a user code. …
  4. Press Kwikset.
  5. Enter the user code you wish to delete. …
  6. Enter the user code again.
  7. Press Kwikset.