Frequent question: How do I take the doors off my Jeep Wrangler?

What tool do I need to take the doors off my Jeep?

Removing the Doors. Remove the nuts on the bottom of each bolt. At the bottom of each of the two bolts that hold each door on the vehicle, there are nuts that must be removed in order to take the doors off of your Jeep. Use a 13 millimeter socket and wrench to remove these nuts.

Can you take the doors off of any Jeep?

Here’s the truth. It is completely legal to remove your Jeep doors and drive on public roads without them, as long as you are sure to take care of a few minor things first. When you remove your Jeep doors, you will also be removing the mirrors.

Is it hard to take doors off Jeep?

Removing your Jeep’s doors is quite easy, but you’ll want to find a safe place to store them when you’re out driving in the open air.

What size bit Do I need to remove Jeep doors?

Using the Torx 40 bit and ratchet, remove the single bolt holding it against the jamb and move the arm out of the way. Moving to the outside of the door, find the bolts that thread upward from below into each external door hinge and remove them using the Torx 50 head and ratchet.

IT IS IMPORTANT:  Quick Answer: How do you reset a door latch on a Bosch dishwasher?

How long does it take to take doors off Jeep?

All told, removing the first door took 11 minutes. And that was with zero prior knowledge. Jeep recommends you have someone help lift the door off the hinges, but if you can lift 47 pounds, you can do it solo.

How much does a jeep winch cost?

$900 and up. This price range works for the most avid off-roaders. In this range, expect the highest pulling capacity (17,500-plus pounds), the most powerful motors, synthetic cabling, and three-stage planetary gear systems.

Where is Jack on Jeep Wrangler?

The Jeep Wrangler tire jack is located in the trunk compartment underneath the foor board.