Best answer: How do you program a Kwikset deadbolt?

How do I reset my Kwikset keypad lock?

A factory reset will delete all codes associated with the lock.

  1. Make sure the door is open and unlocked.
  2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
  3. Press and release the program button. You will hear one short beep.

How do you program a Kwikset 275 touchscreen deadbolt?

How do I change the programming code on my 275 Contemporary Deadbolt?

  1. Make sure the lock is unlocked and the door is open.
  2. Enter your Programming Code – for new installation, default is 0-0-0-0.
  3. Press enter arrow. You will hear one beep.
  4. Press 4 .
  5. Press enter arrow. You will hear one beep.
  6. Enter a new Programming Code.

How do I reset the master code on a Kwikset 913?

How do I program my SmartCode 913 lock?

  1. Open the door.
  2. Remove battery cover.
  3. Press the program button once.
  4. Enter new user code.
  5. Press lock button.
  6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do I reset my Kwikset 910 lock code?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.

IT IS IMPORTANT:  Question: How much does it cost to replace a uPVC door panel?

How do I reset my Kwikset Smartcode master code?

How do I enable/delete the mastercode on my Smartcode?

  1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).
  2. Enter new Mastercode.
  3. Press Lock button once.
  4. Re-enter Mastercode.
  5. Press Lock button once. …
  6. Make sure switch #3 is on, and press the Program button once.

How do you unlock a Kwikset lock code?

To program the first user code:

  1. Press the button marked “program button” once.
  2. Using the keypad, enter a 4- to 8-digit code.
  3. Press the ‘LOCK” button to save the code.
  4. Extend the bolt by pressing- the “LOCK” button.
  5. Enter the new code number. The bolt should retract.

How do you change the 4 digit code on a Kwikset lock?

Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 – 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once.