Press the button for that dedicated key to activate and deactivate the Control Lock. To turn off Control Lock, press and hold the Options key that says “Control Lock Hold 3 Sec” under it for 3 seconds.
How do I turn off the lock on my Whirlpool washing machine?
Push the Start/Stop button to unlock the washer door during the spin cycle. Pause the machine by quickly pressing the Start/Stop button once. After a few seconds, the washer will halt and you’ll hear the door unlocking.
How do you fix a Whirlpool washer lock?
Follow these steps to perform a Whirlpool washer lid lock bypass:
- Unplug the washer and move it away from the wall.
- Remove the top panel by pushing in its retaining tabs or removing its screws.
- Locate the lid lock switch underneath the top panel.
- Secure a strong magnet between the switch and the panel.
How do you reset a Whirlpool washing machine?
The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
Why is my washer lid not locking?
Common solutions for: My Washing Machine Lid Won’t Lock
If the door lock is defective, the washer door will not latch properly. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Why is my Whirlpool washer not unlocking?
The most common cause of a Whirlpool washer door being locked and not being able to open is a faulty lid switch (including the striker). … When it becomes defective, your washer door may not unlock when it’s supposed to. Here’s how to check the lid switch and striker: Unplug the power to the washer.