Best answer: How do I factory reset my Kwikset Smart Lock?

How do I remove a code from Kwikset lock?

Delete A User Code:

  1. Make sure the door is open.
  2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. …
  3. Press 2 to delete a user code. …
  4. Press Kwikset.
  5. Enter the user code you wish to delete. …
  6. Enter the user code again.
  7. Press Kwikset.

How do I know if my Kwikset lock is SmartKey?

If you’re not sure about your own lock, take a close look at it and see if there’s a tiny oval hole next to the keyhole. If so, then it’s a SmartKey lock.

How do I factory reset my Kwikset 910?

How to perform a factory reset:

  1. Remove the batteries.
  2. Press and hold the lock button on the keypad.
  3. Place the batteries back in (while still holding the button)
  4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

How do you unlock a Kwikset lock code?

To program the first user code:

  1. Press the button marked “program button” once.
  2. Using the keypad, enter a 4- to 8-digit code.
  3. Press the ‘LOCK” button to save the code.
  4. Extend the bolt by pressing- the “LOCK” button.
  5. Enter the new code number. The bolt should retract.
IT IS IMPORTANT:  How do you fix a scratch on a metal door?